Merchant Automotive Injector Seal and Return Line Kit - 10409
A replacement element for our FASS Electric Heater (HK-1001). This item is intended for replacement parts only.
The FASS STK-1002 Suction Tube Kit provides a solution to plumbing an aftermarket fuel pump. The Suction Tube Kit is machined from 6061 T-6 Billet Aluminum. The Bulkhead Fitting is comprised of a 5/8" Suction Tube along with a 1/2" Fuel Return Port. This allows you to plum your FASS return line directly to the bulkhead fitting, eliminating all cutting of the filler neck, and significantly speeding up the installation process. The suction tube is fabricated of PTFE Teflon which can be easily cut to adapt to different depth fuel tanks. Properly installed, you can safely operate down to about 1/8 tank of fuel.
Replace your stripped or broken factory plastic bleeder screw with this one made of billet aluminum.
Upgrade the fuel system in your 2001-2004 GM 6.6L Duramax LB7 with the PPE 113072800 Race Fuel Valve. The PPE Race Fuel Valve (heat treated stainless steel) replaces stock or a shimmed pressure relief valve. This valve helps maintain fuel rail pressure during high engine load conditions. It eliminates potential low fuel rail pressure DTC codes P1093 or P0087 (low fuel rail pressure during power enrichment) that are caused by insufficient pressure relief valve spring pressure opening, returning fuel to the fuel tank.
The PPE Billet Aluminium Air Bleeder Screw 513081100 is a simple upgrade that can save you a headache in the future on your GM 6.6L Duramax. Most people know that billet aluminum is a lot tougher than plastic and that toughness means fewer problems over the long haul. So, replace your fragile plastic factory air bleeder screw with the longer lasting billet aluminum PPE Air Bleeder Screw. Damage and distortion that comes naturally with a plastic unit from routine servicing will no longer be a problem because PPE’s Air Bleeder Screw features a Nitrile O-ring and billet aluminum construction.
The ultimate kit to recondition your fuel filter head assembly.
PPE’s Ported Fuel Rail Fitting replaces the restrictive stock fitting. Our fitting increases fuel flow volume from the CP3 pump to the fuel rail simply by making the whole bigger. Adequate fuel flow is vital to producing maximum horsepower. With the increased flow, the Ported Fuel Rail Fitting, is recommended for both high performance and race applications. These fittings benefit both fuel rails, since the driver side fuel rail feeds the passenger side.
The FASS Electric Heater Kit HK-1001 is an optional heater is intended as an upgrade for FASS systems being used in cold regions. Each FASS Titanium Series pump has ports for two electric heaters, that will aid in cold weather starts and keep fuel from gelling up while driving during sub freezing temperatures. The heater will begin warming the fuel block once the key is in the on position and will automatically shut off after the proper temperature has been reached.
With a FASS Fuel System or other aftermarket filtering system downstream of the stock filter, we are able to totally delete the OEM Filter, thus eliminating the time and costs associated with a new filter and install every 5-10K miles.
The FASS HK-1002 High Output Heater Disk can be added to any FASS Titanium or Titanium Signature Series Fuel System to prevent fuel gelling in cold temperatures. When fuel temperatures drop to below 34° Fahrenheit, a thermostatically controlled switch will automatically power on the 300 Watt Fuel Heater Disk to warm fuel as the fuel enters the FASS System, preventing the fuel from gelling in the FASS Filters. The fuel in the tank is also heated as the FASS continually polishes and returns fuel back to the tank. Once at optimal temperature, the thermostatic switch will automatically power off the High Output Heater Disk, eliminating any possibility of overheating the diesel fuel.